How to Add Range Rover 2015+ Key with VVDI Prog and VVDI2

How-to: add a new key to Land Rover Range Rover 2015 up using Xhorse VVDI Prog and VVDI2 key programmer.   It is also work with all key lost by the same way.
2015-range-rover-key-1
Main steps:
Read KVM  RFA data
Write Key
Rewrite data
Step 1: Read KVM Data
vvdi-prog-2015-range-rover-key-1
Remove the KVM module
vvdi-prog-2015-range-rover-key-2
Locate IC Chip RFA MC95S12XET265
vvdi-prog-2015-range-rover-key-3
In VVDI Prog software, select Land Rover->RFA Unsecured (MC95S12XET265)
Check connection diagram
vvdi-prog-2015-range-rover-key-4
Connect KVM module with vvdi-prog through MC9S12 adapter
vvdi-prog-2015-range-rover-key-5
vvdi-prog-2015-range-rover-key-6
Read D-Flash and save data
vvdi-prog-2015-range-rover-key-7
vvdi-prog-2015-range-rover-key-8
Read EEPROM and save data
 
Step 2: Write Key with VVDI2
vvdi-prog-2015-range-rover-key-9
In VVDI2 software, select Transponder Programmer
vvdi-prog-2015-range-rover-key-10
Select Euro->Rover->-Rover/Jaguar 2015-
Load RFA DFLASH and EEPROM data respectively
vvdi-prog-2015-range-rover-key-11
vvdi-prog-2015-range-rover-key-12
select a unused key position
Insert new key into VVDI2 programmer
vvdi-prog-2015-range-rover-key-13
Select Make Dealer Key
vvdi-prog-2015-range-rover-key-14
Prepare dealer key success.
Write the new dump file to RFA module with programmer
vvdi-prog-2015-range-rover-key-15
Check key status
vvdi-prog-2015-range-rover-key-16
Show key ID.  The key can start the car.
 
Step 3: Rewrite Data 
vvdi-prog-2015-range-rover-key-17
In VVDIProg software, open EEPROM and write new dump to RFA module
vvdi-prog-2015-range-rover-key-18
Open and upload DFLASH and write new dump to RFA module
vvdi-prog-2015-range-rover-key-19
vvdi-prog-2015-range-rover-key-20
Install RFA module to vehicle.
Test thew new key.
Done.
http://www.vvdishop.com/service/vvdi-prog-and-vvdi2-program-range-rover-2015-key.html

Leave a Reply

Your email address will not be published. Required fields are marked *