Xhorse MQB Adapter D70F3532 Write Error 00 Solution

Problem:

Tried to read VAG MQB D70F3532 cluster with xhorse vvdi prog and MQB solder free adapter, read works, write does not. Software says write error (00). Any solution?

Xhorse MQB Adapter Read ok, Write Error 00 1

 

Xhorse MQB Adapter Read ok, Write Error 00 2

 

Xhorse MQB Adapter Read ok, Write Error 00 3

Solution:

1.Make sure your vvdi prog software is up-to-date.

2. If reads ok, write does not, use a hot gun to heat the chip with a temperature 200 degrees (Do not exceed 350 degrees).

3. If still fails, then use cut pin method to read/write this cluster.

Leave a Reply

Your email address will not be published. Required fields are marked *