Tag: Xhorse Condor II

Problem:

What happened to Xhorse Condor II clamp 3 and 4 selection? No more tibbe keys? No more single-sided key either?

 

 

Solution:

Just enter the blade option which need use M3 or M4, and the option will tell you.
You can refer to “vehicle database——Ford——F021”.

Here comes the solution to Xhorse Condor XC-Mini Plus II error code 6. Hope it helps if the same error occurs.

Solution:

When decoding or cutting keys by Condor  2, Error Code 6 indicates abnormal conductivity in the probe or cutter.

Follow the step-by-step guide below to solve it.

Step 1: Conductivity Test

Perform a conductivity measurement to diagnose the problem:

1.Navigate to Settings > Machine Test > Electrical Conductivity Measurement.

2.Follow the on-screen prompts to connect either the probe or cutter (not both).

3.Start the test.

 

Step 2: Test Results

If both the probe and cutter light up green simultaneously:

This indicates a short circuit between the probe and cutter.

 

Step 3: Inspect for Iron Filings

Check for iron filings around the three screws above the probe.

Clean the area thoroughly to remove all debris.

 

Step 4: Reinstall Screws

If the problem persists, remove the three screws above the probe.

Clean the area around the hole to ensure no iron filings remain.

Reinstall the screws, but:

Do not overtighten, as this can damage the insulation plastic ring on the screws, causing a short circuit.

Step 5: Check Conductive Wires

Restart the test. If the probe green light turns on before connecting:

• Indicates the probe is in a short circuit state.

Inspect the conductive wires on the probe disk for damage.

• Damaged wires should be wrapped with insulating tape.

Conclusion:

Retest conductivity using the Xhorse Condor XC Mini Plus II Key Cutting Machine’s test interface.

If the issue persists, consider replacing faulty components or contacting the manufacturer.

 

www.vvdishop.com

Problem:

When using Xhorse Dolphin XP005 universal key duplication function, it displayed error code 49. How to fix it?

 

 

Solution:

Just as it said, do Height level adjustment and clamp calibration before cutting.

 

How to do height level adjustment?

•Click Device Info at the bottom
•then click “Height Level Adjustment”
•Next you will want to READ the onscreen directions and follow them exactly.

 

Problem

Xhorse Condor II key cutting machine had error code 57.
The probe is short-circuited.

 

 

Solution

Just as it indicated, the probe is short-circuited.

Follow guides below to disassemble machine

Xhorse Condor II Short Circuit Test Guide

Then check the probe catheter.

 

 

 

Check if it is broken and report result to www.vvdishop.com